top of page
Search

What paint to put over cold galvanizing

GALVANOL IBERIA SL
1 hour ago
2 min read

Cold galvanizing can be left as the final finish, with its matt grey zinc colour, or serve as a primer under a coloured paint. In the second case the finish must be chosen carefully: not all paints are compatible with a zinc-rich coating.

Finishes compatible with GALVANOL

According to its technical data sheet, the following can be applied over GALVANOL: paints that are solvent-based:

  • ALINOL Spray: bright aluminium finish (metallic silver) that adds barrier protection and hides white zinc-salt stains.

  • Solvent-based enamels.

  • Two-component epoxy.

  • Polyurethane.

How long to wait

Let GALVANOL dry for at least 4 to 6 hours before applying the finish. At 20 °C, it is touch-dry in about 20 minutes, fully dry in 4 hours and fully cured in 72 hours.

What about powder coating?

GALVANOL can be used as a primer under powder coating, on two conditions: that it is fully cured (72 hours) and that the oven runs at the lowest possible temperature, up to about 200 °C. The dry film of GALVANOL withstands -60 °C to +160 °C in service.

Mistakes to avoid

  • Water-based paints directly on the zinc, unless their manufacturer specifies them for that use.

  • Painting too soon: trapped solvents can cause blisters or poor adhesion.

  • Thinning GALVANOL with unsuitable solvents. If thinning is needed, use xylene only and in the proportion given in the data sheet.

  • Using a silver paint instead of galvanizing: the finish goes on top of GALVANOL, never in its place.


Is a finish worth it?

In terms of protection, GALVANOL on its own is already a complete system. The finish is a matter of appearance or design, and it also extends the life of the whole system. Two tips: don't sand the zinc before painting (you lose protective thickness; it just needs to be clean and dry) and don't cut down on GALVANOL coats because you're adding a finish: still apply the recommended 2–3. On railings, gates and street furniture it is very common to combine GALVANOL with ALINOL or with an enamel in the colour of your choice.

Always check the technical data sheet of the finish you are going to use and, if you have doubts about compatibility, write to us at info@galvanol.eu. The GALVANOL and ALINOL data sheets are in Products.

 
 
 

Comments


Stay informed, subscribe to our newsletter

Thanks for subscribing!

bottom of page