top of page
Search

C4 and C5 environments: how to protect steel in industrial and coastal areas

GALVANOL IBERIA SL
1 hour ago
3 min read

The same steel section can last decades in an indoor warehouse and rust in a few years by the sea. That is why ISO 12944 classifies environments by corrosivity and requires protection to be adapted to each one. Categories C4 and C5 are the most common in industry, ports, water treatment plants and solar parks near the coast.

What a C4 environment is

ISO 12944-2 considers C4 (high corrosivity) to be industrial environments and coastal areas with moderate salinity. Indoors, it corresponds to chemical plants, swimming pools or shipyards. In C4, unprotected steel loses between about 400 and 650 g/m² in the first year.

What a C5 environment is

C5 (very high corrosivity) covers industrial environments with high humidity and aggressive atmosphere, and coastal areas with high salinity. Indoors, buildings with almost permanent condensation and high pollution. Here first-year loss can range from about 650 to 1,500 g/m². Above it is CX (extreme), typical of offshore.

How to know which category your project is in

  • Distance to the sea: salt is carried by the wind; on the seafront, think C5.

  • Nearby industry: fumes, chlorides or sulphur compounds raise the category.

  • Humidity and condensation: areas with frequent dew or standing water.

  • Microclimates: an area sheltered from rain can accumulate salt and be worse than an exposed one.

When in doubt, specify the higher category. The extra cost of a few more microns is small compared with an early repair.

What durability you need

ISO 12944 defines four ranges: low (up to 7 years), medium (7-15), high (15-25) and very high (more than 25). Durability is the expected time until the first major maintenance. It is a technical reference, not a guarantee.

Which system to choose with GALVANOL

According to the technical data sheet and tests to ISO 12944-6:

  • C4 high (15-25 years): from 80 µm dry in 1-2 coats.

  • C4 very high (more than 25 years) and C5 high (15-25 years): from about 121 µm in 1-2 coats. This is what was tested with 1,440 hours of salt spray and 720 hours of humidity.

  • C5 very high (more than 25 years): from 130 µm in 2 or more coats.

  • CX: 2-coat system with a minimum of 150 µm according to ISO 12944-9.

As a guide, the can or pail gives about 250-280 g/m² for 40-60 µm dry. Calculate consumption according to the thickness you need and allow for application losses.

Why zinc works in C4 and C5

In aggressive environments, the problem isn't just rain: it's impacts, bolts and welds. A barrier paint protects while intact; once damaged, rust creeps underneath. Zinc also protects cathodically: it sacrifices itself instead of the steel. In the GALVANOL test, corrosion did not advance at all from the scribe (0 mm) after 1,440 hours of salt spray.

Keys to reaching the expected life

  • Prepare the surface properly: Sa 2½ blasting on new steel or careful mechanical cleaning for repairs.

  • Measure dry thickness with a gauge, not by eye.

  • First protect welds, edges and bolts by brush, as that is where corrosion starts.

  • If a finish is applied, use compatible paints (solvent-based) and respect the times.

Do you have a project in a C4 or C5 environment? We are the manufacturer: write to info@galvanol.eu and we'll help you define the thickness and system. Technical and safety data sheets are in Products.

 
 
 

Comments


Stay informed, subscribe to our newsletter

Thanks for subscribing!

bottom of page