Brush, roller, spray gun or spray can: how to apply zinc-rich paint
GALVANOL can be applied by brush, roller, spray gun or spray can. The right method depends on the size of the surface and the shape of the part.
Brush
Ideal for welds, joints, corners and fasteners. Use natural bristles. It is the method that penetrates difficult areas best: even if you spray, it is worth brushing welds and edges first.
Roller
For flat surfaces and wide sections. Use a solvent-resistant roller, such as 100% wool. Faster than a brush and with good thickness.
Conventional spray gun
For large structures. Pressure 2–3 bar, nozzle 2.0–3.0 mm. You can thin up to 15% by weight, with xylene only. Remove the inner filter: the zinc clogs it.
Airless
For large jobs. 80–120 bar and 0.015–0.025" tip. Very high output with uniform thickness.
Spray
The GALVANOL Spray 500 ml is the most convenient option for touch-ups, repairs and small parts. Shake for at least 1 minute, spray from 25–35 cm and shake again every 10 seconds of use.
General tip
Whatever the method, mix the product very well beforehand and repeat every 20–30 minutes: zinc is heavy and settles at the bottom.
Have a project? We are the manufacturer: write to info@galvanol.eu for quotes, samples or technical advice. Technical data sheets and safety data sheets are available in Products.



Comments