Bolts, anchors and joints: the weak points of any steel structure
If you inspect any steel structure that is a few years old, you'll see that rust almost never starts in the middle of a beam. It starts at the bolts, nuts, anchor plates, welds and edges. These are the weak points, and that's where you need to pay the most attention.
Why joints rust first
They collect water and dirt: the gaps between parts retain moisture for hours.
They are fitted after galvanizing: site bolts, cuts and holes drilled during assembly are left unprotected.
Paint is thinner on edges: on a sharp edge the paint pulls back and leaves less thickness.
Welds burn off the zinc and leave bare steel around them.
Galvanic couples: joining different metals (for example, untreated bolts on galvanized steel) accelerates corrosion.
How to protect them properly
Clean thoroughly with a wire brush: you need to reach sound metal in the gaps too.
Degrease with xylene; bolts usually come with factory oil.
Stripe coat by brush: before the general coat, apply GALVANOL by brush on welds, bolts, edges and corners. This is what its technical data sheet recommends for difficult areas.
General coat over the whole part.
Repeat the general coat; at critical points, don't worry if it ends up a little thicker (without exceeding 200 µm).
Spray for bolts already fitted
For post-assembly bolts, anchor bolts and site touch-ups, GALVANOL Spray 500 ml is the quickest option: it reaches corners where a brush struggles and leaves an even coat. Shake well, apply at 25–35 cm and give two or three light passes.
Compliance with standards
GALVANOL meets ISO 1461 and ASTM A780 as a repair coating for hot-dip galvanizing, so it is valid for repairing cuts, holes, welds and assembly bolts on galvanized structures. If you want to know more about how to do it, read our guide to repairing welds and cuts on galvanized steel.
Have a project? We are the manufacturer: write to info@galvanol.eu for quotes, samples or technical advice. Technical data sheets and safety data sheets are available in Products.



Comments