top of page
Search

7 mistakes when applying zinc-rich paint (and how to avoid them)

GALVANOL IBERIA SL
1 hour ago
2 min read

When a customer tells us cold galvanizing "didn't work", we almost always find the cause in the application, not the product. The good news is that these mistakes are easy to avoid.

1. Not preparing the surface

Zinc has to touch the steel to protect it. If you apply it over loose rust, old paint or grease, there is no contact and the coating peels off. Solution: brush or sand down to sound metal and degrease with xylene. More details in our guide to surface preparation.

2. Not mixing the product properly

Zinc is very heavy and sinks to the bottom of the can. If it isn't mixed, you are applying solvent with little zinc. Solution: mix thoroughly before starting and stir again every 20–30 minutes. With the spray, shake for at least 1 minute until you hear the ball rattle and shake again while you work.

3. Thinning with the wrong solvent

GALVANOL is thinned only with xylene, and only if needed (for example, in a spray gun, up to 15% by weight). Other solvents can spoil the product.

4. Applying a single thick coat

A very thick coat takes a long time to dry, can sag and crack. Solution: several thin coats (about 40–60 µm each), letting each one dry (touch-dry in about 20 min at +20 °C).

5. Falling short on thickness

The opposite extreme: a single thin coat "to see how it goes". Durability depends on thickness. Solution: at least 2 coats, 3 in marine or industrial environments. Use the calculator so you don't run short of product.

6. Going over the thickness

More is not always better: above about 200 µm dry, micro-cracks can appear. 3–4 normal coats are more than enough.

7. Overcoating with the wrong paint or at the wrong time

If you want a finish, use solvent-based paints and wait at least 4–6 hours. We explain it in how to paint over GALVANOL.

Bonus: forgetting the difficult spots

Welds, bolts and edges need a brushed stripe coat before the general coat.

Have a project? We are the manufacturer: write to info@galvanol.eu for quotes, samples or technical advice. Technical data sheets and safety data sheets are available in Products.

 
 
 

Comments


Stay informed, subscribe to our newsletter

Thanks for subscribing!

bottom of page